MiniPro has just released a new a chassis dynamometer that measures the RPM, Kv, voltage, current draw, power and torque output of your 1/10th and 1/12th RC car. This dyno is perfect for motor analysis, ESC (boost) adjustment, brushless sensor adjustment, gearing calculation, tire selections, and much more.
The MiniPro dyno is coupled with to a knurled roller via a pulley and belt to accelerate the inertial mass. The electronic board takes the flywheel’s inertia (resistance of an object to a change in its state of motion), measures the rate it takes to accelerate and calculates the output power and torque of your vehicle. It repeatedly measures and calculates power in small increments to produce an accurate graph on a PC (Windows) of the engine’s power characteristics.
TECHNICAL SPECIFICATIONS:
- Torque: 2N/m Max (with GT2 2mm Belt)
- RPM: 100K Max
- Units: English & Metric
- Adjustable Reading and Logging Rate: Up to 50Hz
TOOLS and EQUIPMENT REQUIRED:
- Allen: 1.5mm, 2.0mm
- Phillips Screw Driver
- Soldering Iron
- Electronic Speed Controller (ESC)
- Battery to Power ESC and Motor.
- R/C Transmitter and Receiver Or Servo Tester
(Not required if using ESC Throttle Controller Board) - Windows PC with 1 USB Port
(Two USB ports are required when using the ESC Throttle Controller Sensor)
Source: Minipro
dyno turnning